Has anybody made the SDRPlay with HDSDR work as a pan adapter using the IF out? When I tried to use HDSDR in IF mode, it complained that the IF frequency was too low (current version of the driver), so I had to resort to using the RX ant in/out with the SDRPlay, which works but is not the most elegant solution.
73 Mike K5TRI > -----Original Message----- > From: Elecraft [mailto:[email protected]] On Behalf Of Don > Wilhelm > Sent: Thursday, December 17, 2015 1:17 PM > To: [email protected]; [email protected] > Subject: Re: [Elecraft] K3S 15KHz output? > > Bob, > > No 15 kHz output, but better for SDR experimenting, use the IF output at > 8.215 MHz. That gives you a output that is prior to any IF filters in the K3S. > If you want baseband I/Q outputs, you can connect a softrock receiver or > LPpan2 to that IF output. > > 73, > Don W3FPR > > On 12/17/2015 3:57 PM, Bob Novas wrote: > > Far as I can tell, there is no 15KHz output from the K3S that can be > > used for experimenting with SDR. Is that correct? Thanks, Bob W3DK > > > > > > __________________________________________________________ > ____ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html Message > delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
