There is a button on the front, that needs to be pushed until the green light 
on the left starts flashing. One then has three seconds to send RF to it for it 
to either recall a stored setting or re-tune to find the best match.

There is also a side jack where one can send the correct band data to it, if it 
is available from the transmitter.

Jim / W6JHB


> On   Saturday, Dec 26, 2015, at  Saturday, 11:11 AM, Lynn W. Taylor, WB6UUT 
> <[email protected]> wrote:
> 
> I don't know the T1 either, but the design seems simple enough: it's meant to 
> run on batteries, so one has to wake it up to do the tuning.
> 
> Does it need the band information to tune, or does it just need to be 
> "tickled" somehow to wake up the tuner?
> 
> I see a few buttons that I'm guessing would "wake" the tuner and then it'd 
> match the load and go back to sleep?
> 
> -- Lynn
> 
> On 12/26/2015 3:46 AM, Dave B via Elecraft wrote:
>> The SoftRock kits:  The embedded micro controller they use for USB<>I2C 
>> work, may have a spare pin or two, or you can hang another I2C I/O chip on 
>> the I2C bus (a PCF8574 for example) to get generic digital I/O ports.   I've 
>> done that to control a bank of band filters between the antenna and a 
>> SoftRock here.  The hardware was fairly simple, re-engineering the software 
>> however, is an "ongoing" project... 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[email protected]
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to [email protected]

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]

Reply via email to