The firmware is up to date (MCU 2.34, DSP 1.33).
I have done a TX gain calibration and the SWR indicator is still reading
as before.
Dana Browne, AD5VC
On 12/27/2015 7:15 PM, Walter Underwood wrote:
What version of firmware are you running?
I’d update the firmware and run a TX gain calibration with the KX3 Utility.
wunder
K6WRU
Walter Underwood
CM87wj
http://observer.wunderwood.org/ (my blog)
On Dec 27, 2015, at 5:10 PM, Dana Browne via Elecraft
<[email protected]> wrote:
Oops, pressed enter too soon.
I neglected to mention that the only additional board I have in the KX3 is the
antenna tuner, I do not keep batteries in it, and the serial number is #150, so
a rather early model. I was unable to find anything in the KX3 manual about
the SWR meter, but I recall seeing something posted on the reflector about it
being pretty reliable.
--
Dana Browne, AD5VC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
