Ken,
That is normally the result of unmatched transistors for Q7 and Q8, but
Elecraft has been supplying matched transistors for the last 3 years.
I suspect that you have some incorrect components in the Q7/Q8 base circuit.
After checking everything in the Q7/Q8 base circuit, check the PA bias
voltage before installing the new Q7/Q8.
Do a TUNE and monitor the voltage at the base solder pads for Q7 and
Q8, the voltage should be between 0,60 and 0.64 volts. If it is not
replace Q11 and Q13 and then recheck.
Check all the components in the Q7 and Q8 base circuit for proper values
and good soldering.
73,
Don W3FPR
On 12/28/2015 8:52 PM, K and K Stuber wrote:
While operating my K2 (SN 7581) on CW I heard a loud pop! I traced it to
blown Q7 and Q8. They are physically blown apart. The K2 was operating
normally before this happened. Everything else seems to be OK except for no
power output. The driver seems to be working; I can key the radio and hear
it in another RX. The K2's RX is working normally. Any thoughts as to why
this happened would be appreciated.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
