Hello
I have my new KXPA100 connected to the KX3 as described in the manual ,
via the adapter cable (page 13 of the manual) ; all is working fine and
the KX3 communicates with the KXPA100. I have made already some qso's at
100 watts.
but ..
when I was using the KX3 barefoot, it was connected to my PC via the
KXUSB cable at ACC1, which provides an RS232 to USB conversion ; and
logger32, which is my logbook software, was reading the KX3 frequency on
the simulated COM6 port.
I was expecting that the same will occur when I use the same hardware
connected this time to the RS232 exit on the KXPA100 ; but now logger32
doesn't receive the frequency info from the KXPA100 when the PA mode is
selected. When the PA mode is OFF , logger32 reads the correct frequency
If I come back to the KX3 barefoot configuration, logger32 receives the
frequency data as before.
What did I missed ? I suppose something is not behaving as I was
expecting on the RS232 exit from the KXPA100 when he is ON ?
Thanks for any help !
Best season's greetings to everybody on the list
73 de Chris / F6FTB
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
