Kevin,
That is what happens if only one of the I/Q channels is connected. Make
certain your I/Q cable is fully inserted - check both ends.
73,
Don W3FPR
On 1/10/2016 7:42 AM, kevino z wrote:
Not sure if it was the loading of the new KX3 firmware, or if I changed some
settings, but now on my PX3 panadapter, I see everything symmetrically mirrored
around the center. So for example, If there is a signal at Center frequency
-50kHz, it appears at +50kHz too.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
