Are you sure you have configured fldigi to use the correct sound device? With my K3 set to CONFIG:LINE OUT = Nor 10, microHAM interface with the RX MAIN pot at ~ 10:00, and "Line (microHAM CODEC)" level set to 80% in the Windows Sound Control panel (Recording Devices) - Windows 10, there is no "starvation" (clean square waves visible) in the fldigi "scope" view.
73, ... Joe, W4TV On 1/13/2016 4:02 PM, paul ecker via Elecraft wrote:
In response to my question on the Win- Fldigi Reflector that I asked regarding waterfall adjustments and the fact that I was seeing no signals on the Fldigi Scope, Dave W1HKD responded,--- If you need those controls set to the maximum range and lowest absolute signal (or close to it) then you are probably starving Fldigi for Rx audio-- So my question concerns Dave's comment that I am "Starving" Fldigi for audio Rx. Do other K3/ Fldigi users when operating in PSK 31 mode see any signals on the Scope view? I have tired adjusting the Rx pot on my DK II and Windows - Sounds- Recording -Levels with no change.. in Fldigi. I am able to decode signals.What settings on the K3 affect Rx audio to Fldigi? (Setup:Win 7 PC, micoHam DKII interface.) 73 Paulkc2nyu ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
