There are LEDs on the P3 front panel and on the SVGA board, both should be blinking. If you plug a keyboard or USB thumbdrive into the SVGA board, you should see another LED light up on the SVGA board.
The next thing to try is a parameter reset on the P3. Do that holding down the MENU key and then tapping the POWER key. This will reinitialize any settings so you may first want to save the P3 configuration using the P3 Utility. Next check the revisions of the all the FPGA files located on the SVGA board. You mentioned that you upgraded the firmware, but maybe one of these files could be corrupted (they control the video chip). Rotate the encoder to the SVGA sub-menu and then enter it. Rotate the encoder to select SVGA FW and select using a push of the encoder. You should see 1.04 in FPGA 0 to FPGA 4. If none of that works, email me directly at Elecraft. My email address is pauls at you know where dot com. Kind regards, Paul -- View this message in context: http://elecraft.365791.n2.nabble.com/P3-SVGA-help-tp7612682p7612690.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
