No. What will matter is the quality of the connectors. The 1st IF
output from the K3 is low level, the P3 is basically a fairly sensitive
HF receiver, and bad connectors can create all sorts of problems.
You didn't give a S/N range for your K3, but there is a simple mod
[destroy one surface mount resistor and replace it with a non-SMC
resistor] that will raise the IF output.
73,
Fred K6DGW
- Northern California Contest Club
- CU in the Cal QSO Party 1-2 Oct 2016
- www.cqp.org
On 1/15/2016 5:15 PM, Bert Rollen wrote:
I am setting up a LP-PAN with my K3.
Will I cause much problem by using a 75 ohm jumper on the IF ? (I happen to
have several fairly nice 24" Belden 8263 BNC jumpers on hand).
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
