From: Richard [mailto:[email protected]]
Sent: Saturday, January 16, 2016 8:50 PM
To: [email protected]'
Subject: Low power KX1
I am very new to the world of CW. Several months ago I built a KX1. Once I
was able to receive with it, I built the 30-80 band set, and once it was
installed and working, I built the ATU. With the ATU was the first time I
was able to measure power. I am only getting .4W out of internal, and 1W
with a 13 volt power supply. So I did the power modification changing the
resistors, and now I get .6 internal and 2W with 13V.
I could sure use some advice. I do not have a bridge or watt meter. I do
have a good scope Can I measure the signal voltage across 50 ohms?
Thank you in advance.
Richard
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
