Dave,
AFAIK, the addition of the KPA3 should not have any effect on the
operation of the KRC2.
Check the jumpers in the KRC2 against the AUXBUS configuration for the
K3 on page 23 of the KRC2 manual.
The two indications of K3 menu for the KRC2 show "-" and the "Turn On
PA" message are making me think that there is some kind of conflict on
the AUXBUS signal internal to the K3 or KRC2.
73,
Don W3FPR
On 1/25/2016 4:42 PM, Dave Glenn wrote:
I recently had the 100 Watt amp added to my K3.
I went to set it up with and use with my transverters and KRC2 menu item
shows -
Cabling looks good going from 15 pin on the K3 to the 9 on the KRC2.
If I power cycle the KRC2 while the K3 is on it shows Turn On PA and is
locked up.
Is there some setting I have forgotten?
Tnx, Dave N6TEB
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
