If i had only known that Eccostrip and Stripvar were going to become unavailable, I would have stocked up years ago (thanks, OHSA/EPA). The alternatives certainly do not beat just brushing a thick liquid on the end of the wire and wiping it and the enamel off a few minutes later.
73, Bob N7XY ---------------------------- It takes less time than that to strip this new stuff using either a blob or a sharp edge. Make it about 10 seconds per lead <G> My concern with the newer stuff is that the enamel comes off a bit too easily. When winding transformers it's important not to shed enamel where it could short the windings. Ron AC7AC _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
