Turning on my rig a few nights ago (K-3 Serial #6512) I got a strange response. The rig would not turn on. All I got was a blinking TX light and screen display reading of MCU LD. My K-3 Utility program could not access the rig through the COM port. I looked up the reset instruction saying I should use the key combination of POWER + SHIFT 0/0 (whatever that is). Assuming I did it right, it didn’t work.
I drafted this email while I was thinking about what to do. Then I tried POWER + 0. In response the rig turned on normally. What just happened. Was I just lucky the last time? Jimmy, WA4ILO ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
