The connectors on the MicroHAM cable and the Elecraft RJ-45 adaptor are properly seated. If I plug (swap) the MicroHAM DB-15 and USB into an obsolete DigiKeyer using the same radio, cables and computer the router recognizes the K3S frequency and it all appears to work properly. The other strange thing I was having using this DigiKeyerII is when I opened Writelog the K3S immediately went into transmit mode, that is something that I have never seen before. I had not used this DigiKeyer II in six months and never with a K3S.
John KK9A Joe Subich, W4TV lists at subich.com Sat Feb 6 16:47:19 EST 2016 Are you sure the RJ-45 connector is seated correctly and none of the wire/contacts have been crossed/dislocated? 73, ... Joe, W4TV On 2/6/2016 4:14 PM, john at kk9a.com wrote: > I have two MicroHAM DigiKeyer II's that I have used for years with Yaesu > FT1000 Mark-V transceivers. I recently switched to using Elecraft K3S radios > and purchased two new MicroHAM cables. I cannot get the MicroHAM router to > recognize the frequency of my newest K3S. I have the radio RS232 set to > 38400 b and the MicroHam set to radio K3 38400 baud. I am also having other > issues getting this to work on RTTY, but those could be configuration > problems. I switched cables and DigiKeyers with a working system and this > still does not work. Is there a K3S setting that I am missing or is > something wrong the RS232 port of my new transceiver? > > John KK9A ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
