This is for anyone who may be following my previous post on this problem. I took some voltage measurements, and I am getting the following KIO2 readings:
J1 pin 2= +12.7 Volts U1 pin 11= 0 volts U1 pin 12= +1.4 volts All other readings are pretty close to the table of voltages in the KIO2 manual p. 23. The two U1 readings above can be traced back to pins 25 & 26 of the MCU on the Control Board. I have done a hard reset of the K2 and stillhave the same readings. Do I have a flakey MCU? Please help... anybody!! 73, Mark Baugh W5EZY Grenada MS __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
