Michael,
Did you change the jumper next to the BNC jack when you installed the
KAT1? If you failed to do that, the K1 would show a low power even
though it was actually developing full power output.
Make sure the ATU menu is set to CAL P.
If you are measuring power output with an external wattmeter, then check
the soldering of the KAT1 toroid leads. You should not see any enamel
on the solder side of the board and you should see a bit of tinned lead
above the board.
73,
Don W3FPR
On 2/13/2016 11:11 PM, Michael via Elecraft wrote:
I just built a new K1 and had some problems with the output power. To make
a long story short I
ended up having to lower the values of R5 and R11... This brought the
power levels up on
the 40 M band from 1.5 to 6.5 Watts and on the 20 M band from 0.5 to 5.5
Watts.
Figured all was well now until I installed the new ATU....
For some reason my output power on the 20M band into a 50 Ohm dummy load
is
only around 0.7 Watts now with the ATU installed. If I remove it - it
goes back up to normal!
Any ideas?
Thanks,
Michael
n2zdb
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
