Look into Ecoflex. http://www.vibroplex.com/contents/en-us/d39.html
I'm using it from the gear in the shack through the wall --> Andrew Heliax to
the base of the tower---> Ecoflex up the tower.
So far, so good.
I measured some Buryflex years ago for a friend who had 100' dropped shipped to
me. It's in the storage room someplace and not in my antenna system.
On 2/23/2016 2:41 PM, Robert Nobis wrote:
Jim,
Thank you. I have heard of Davis RF BuryFlex, but have not seen it offered by
any of the on-line sellers. I assume you purchase direct from the supplier? I
concur with using Amphenol connectors.
Thank you.
73,
Bob Nobis - N7RJN
[email protected]
On Feb 23, 2016, at 11:10, Jim Brown <[email protected]> wrote:
On Tue,2/23/2016 9:05 AM, Robert Nobis wrote:
I am in the process of setting up my shack for SO2R operation with my K3 and
KX3. Just wondering what the best coax type to use for jumpers and
interconnections within the shack? I want to make sure I have the best
possible isolation between the two rigs.
Faced with exactly that issue, I chose Davis RF BuryFlex as the best compromise
between shielding effectiveness and flexibility. I use only Amphenol 83-1SP
connectors that I carefully solder myself. And I use only Amphenol adapters
where required (elbows, barrels, Tees). When a male N-connector is required, I
use the excellent Andros connectors.
73, Jim K9YC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
