"not drastically" was what was used - trying to mean 'very little'.
73,
Don W3FPR
On 2/27/2016 3:12 PM, Mark Petrovic wrote:
Thank you, Don.
What does drastically mean in this context?
On Feb 27, 2016, at 11:59 AM, Don Wilhelm <w3...@embarqmail.com> wrote:
Mark,
You are effectively reading the voltage drop across D16.
That 600mV drop across D16 will not drastically affect the operation of the K1.
If you would like a bit higher voltage on the PA transistor, you can increase
the voltage of your power supply a bit (the K1 upper voltage spec is 15 volts).
If you are running on batteries, it will make a little difference.
If you would like a lower voltage drop across D16, replace it with a 95SQ015
which is available from Elecraft as p/n E560009 (it is used in the K2 as the
series reverse voltage protection diode.
73,
Don W3FPR
On 2/27/2016 2:32 PM, Mark Petrovic wrote:
I'm performing the DC voltage checks (page 30 of the instructions), which occur
immediately after installing the power switch on the RF board.
P1 pin 16 is supposed to be supply minus 300mV, but I get 600mV. Is this a
cause for concern?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
