Have you gone to Config: Ref Cal and tapped 2 to enable XREF IN ? See page 63 of the manual.
73 from David GM4JJJ > On 28 Feb 2016, at 05:31, Tighe Kuykendall <[email protected]> wrote: > > I picked up the Leo Bodnar frequency reference and a K3EXREF board after > reading a couple of threads here. I Installed the board according to > instructions, took static precautions, am using a known good cable from the > K3 to said reference. I can clearly hear the 10MHz tone on my K3 when I tune > a VFO to 10MHz and the signal goes away if I disconnect the coax from the > freq reference. I've checked all of the tmp connectors and reseated the > K3EXREF board on the K3REF board and all pins are properly engaged. But > still no * on the display and the REF CAL setting remains unlocked. > > Am I missing something, is there something to do to enable the K3EXREF other > than plug in the freq reference and wait for some magic to happen? > > 73, Tighe NK4I > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
