I too am a little confused as to "Complete power down". If you do not shut the KX3/KXPA100 down using the power off buttons ( band /autotune) but shut down the external power source, the KX3 senses that and switches to internal bat if installed. This switches the power out to below 10W which sets PA off. When the KX3 is finally shut down it remembers it's last state and comes up as PA off. I have both KX3 and KXPA100 on same supply. I turn on supply then then KX3 which after boot sequence turns on KXPA100. Not sure if this will help, but I have seen what you are experiencing when the power is accidentally shut down before shutting of KX3.
-- View this message in context: http://elecraft.365791.n2.nabble.com/KX3-power-on-sequence-tp7614806p7614813.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
