K2UF, Looking at your cut, you left off the ";" at the end of the command. Each command needs the ";" at the end. -- 73's, and thanks, Dave
For software/hardware reviews see: http://www.nk7z.net For MixW support see: https://groups.yahoo.com/neo/groups/mixw/info For SSTV help see: http://groups.yahoo.com/neo/groups/MM-SSTV/info On Tue, 2016-03-01 at 17:44 -0800, Alan wrote: > What version of P3 firmware is installed? You need at least v. 1.57. > > Alan N1AL > > > On 03/01/2016 12:59 PM, Joe K2UF wrote: > > Trying to use the commands in the P3 pgmrs ref. If I enter a > > command into > > the P3 utility or the K3 utility app they work fine. If I try to > > place one > > of the P3 commands (ie #SPN000500 ) in one of the P3 slots using > > the > > attached keyboard it does not work. I do not have a problem using > > any of > > the K3 commands. > > > > Any ideas/help > > > > Joe K2UF > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
