Spend the $20 for a generic SDR, do the direct sampling mod on it, then run HDSDR in windows. Connect the antenna jack to the IF output on your K3 if you have the option for that. Receive center freq on the SDR 8.215MHz, You'll see everything the IF on the RIG is seeing.
To configure filter use the K3 Utility to set which modes in which it's permitted to be used. Jerry Moore CDXA, INDEXA, SKCC, Fists AE4PB, K3S - S.N. 010324 http://www.qrz.com/db/AE4PB An Amateur is - Considerate, Loyal, Progressive, Friendly, Balanced, and Patriotic. -----Original Message----- From: Elecraft [mailto:[email protected]] On Behalf Of Kjeld Holm Sent: Wednesday, March 02, 2016 8:07 AM To: [email protected] Subject: [Elecraft] Lazy poor man's Skimmer Dear Elecrafters I am the fortunate owner of a K3 100 with subreceiver and 13kHz, 2.8kHz, 1.8kHz, 400Hz and 200Hz roofing filters. My wish is to use Skimmer to monitor as much as possible from 3.500 to 3.525kHz for CW signals. But I am not ready for the economic and practical challenges of using P3 or a SDR radio. My plan was to use my 13kHz FM filter to receive CW but that seems not to be "allowed". That is what K3 Util tells me when I try to enable the 13kHz for CW reception. Any suggestions? Or is it just plain impossible? Vy 73 de OZ1CCM, Kjeld ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
