A while back there was some information about using a 48 key keypad for
controlling the K3. It was done by connecting the keypad to the P3
(expensive extra board required) and controlling the K3 by triggering
assigned macros in the P3 that in turn are sent to the K3 for rig
control. Has anyone had success using the keypad connected directly to
the K3 for rig control (serial port)? I envision that each key would be
individually programmed with an instruction, rather than keying a memory
position in the P3.
BIll W2BLC K-Line
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
