Randy,
I suggest you contact K3support - they can likely give you a small
number of probable failure points. That will allow you to choose field
repair or send it to Watsonville.
73,
Don W3FPR
On 3/12/2016 10:36 AM, Randy Farmer wrote:
Due to an unlucky combination of station configuration and a bad TX
gain calibration in my K3s (since corrected) I've managed to burn out
something in the front end chain in my second station K3. I've
verified the problem is in the signal path between the ATU inputs and
the input to the main receiver. The Sub receiver is working correctly
when connected via the AUX RF input connector, but dead in normal
split mode. I've had a look at the schematic and can see a couple of
probable points of failure.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
