At least two ways. One unplug the power connector to the KPA100 and use the old round power connector on the K@ it will auto detect and go into QRP mode. Two, go into the secondary menu and turn off the KPA100. Of course you can also remove the KPA100 and install the QRP top but that is really not necessary un less you want to use the battery option then you would neet to either swap the tope or the ultimate is to build the KPA100 into an EC2 box then you can just unplug the K2 and go. You can also have the KAT100 live in the EC-2 box with the KPA100
Don Brown KD5NDB ----- Original Message ----- From: "Darwin, Keith" <[EMAIL PROTECTED]> To: "Elecraft Discussion List" <[email protected]> Sent: Thursday, February 23, 2006 10:55 AM Subject: [Elecraft] K2/100 in QRP mode? What does it take to make a K2/100 run QRP? - Turn down the power? (fine for CW what about SSB?) - Unplug the KPA100 and put the old top back on? - Keith KD1E - _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
