Hi Gang,
I have the P3 with SVGA option and a K3. The firmware appears up to date, according to the P3 Utility. I've set CenterEn: ON and use the CENTER button and the P3 knob to move DX pileups more into the center of the display. When I hold the CENTER button while in CENTER mode, the P3 display returns the VFO A green bar to the Center position, and the red bar of VFO B to the correct vertical position relative to VFO A. However, the SVGA is hopelessly confused at this point, and the VFO A green bar and the VFO B red bar are incorrectly positioned. A power-cycle on the P3 is required to return the SVGA to normal. I thought I might be getting RF into the SVGA port - but now have discovered this happens without any TX at all. Any suggestions or further things to check will be greatly appreciated! Thanks. - 73 and good DX de Mike, <http://www.qrz.com/db/k6mkf/> K6MKF, President - <http://ncdxc.org/index.html> NCDXC ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
