Hi Don, Ok thanks for the info. Whew, that's good because I managed to ruin it anyway having made a mistake with it that I'm too ashamed to admit to on the reflector hi hi.
And thanks for the warning about flush-cutting the daughter board. In fact, I did find some discussion of this in the archives so I went over mine with my flush cutters last night and got all the nubs as close as possible to the board. The manual describes putting the lock washer under the standoff also - maybe this was a change in the new manual? In any case, I checked the clearance with a straightedge over the two standoffs this am too and it's veeeery close hi hi. So I'll be careful with this at assembly once I get to that point. I don't remember this on my first K2 which is #6882 I think. Maybe it had a different encoder? I'm too lazy to take it apart to look hi hi. On to the RF board now. I'd forgotten what fun this kit is to build! 73, LS W5QD -- View this message in context: http://elecraft.365791.n2.nabble.com/K2-encoder-kit-4-pin-connector-tp7615471p7615478.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
