Hi Steve:
I previously wrote
To join the two wires, I use a home=made butt-joint connector
fashioned from a 3/4" length of brass (hobby) tubing purchased
at my nearby hardware store. I Stripped the ends of the two
wires to 3/8" each, bought a length of hobby brass tubing which
would just barely accept #10 wire,
Aaaayyy! Should have typed #8 wire, not #10, continuing...
slipped one wire into the tubing and soldered it into place,
filling the empty 3/8" of the tubing about 1/3 full of solder as
well. Then I inserted the other wire, reheated the joint and
pushed the wire into the tubing. The solder flowed to the new
wire, a bit dropped to the floor, and the rest completely filled
the tubing. I then applied 2 layers of heatshrink tubing over
the finished joint.
Worked like a champ.
And it still does.
73,
Tom Hammond N0SS
At 12:01 PM 2/24/2006, you wrote:
Elecrafters:
Is the Powerwerx ATC 20- amp fuse and holder suitable for fusing the
power supply lead to the K2/100?
73,
Steve
AA4AK
K2 # 5383 (almost in hand)
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
