I recently got a KX3 and KXPA100. I have a Cobra UltraLite Kid up in my loft with a 4:1 balun and coax down into the floor below. I can tune most bands fine (I don’t do 80/160 due to plasma TV noise next door). However, when I try to tune the KXPA100 at 6m it often hangs in transmit. Or it stops with two dashes displayed. If I check the antenna with my RigExpert AA-600, the low end of the band is between 3:1 and 4:1, whereas the upper part goes as low as 1.08 around 53 MHz. I just went to 50.100MHz and pressed tune the display on the KX3 shows 3.1 and is stuck with the xmit light on until I press tune again.
Has anyone seen this? Thanks and 73, Erik Tkal - W1QED ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
