You should set the transceiver's dial to 14095.6 USB. Then, as the audio
tone generated is 1500 Hz, the actual transmit frequency will be 14097.1
On receive same story: receiving with the dial set to 14095.6 a 1500 Hz
tone will be audible. That's it...
73,
Peter
Op 2016-04-02 21:54 schreef Aaron K5ATG:
I'm wondering if I am missing something. I'm trying to run WSPR with my K2.
I'm using a Signalink USB and have the transmit set at 140971 and receive
at 14956 (as per WSPR instructions). My PC clock is in sync with the WSPR
program, and I have the AF Gain at about 1 db. I have it set at 20%
Transmit. The Idle box is unchecked and the K2 is set at USB. I see a
bunch of signals on the waterfall, but I am not receiving or transmitting
any signals.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
