My perspective comes from the early days of home brewing PC's.
In the "good old days" with soldered BIOS EEPROMS and manufacturer
approved command line flash utilities it was entirely possible to trash
a motherboard. Lose power during a BIOS update or a cosmic ray takes out
a section of the chip (I'm only partially kidding) and you got to buy a
new motherboard. Your chances were 60/40 at best, a little better than
flipping a coin. Next came socketed BIOS where all you had to do after a
failed flash was buy a new chip from AMI, Award or Phoenix.
These days with dual BIOS chips on board, BIOS backed up to hard drive
and GUI flash utilities it's a lot easier to recover from a failed flash
and not nearly as expensive, but failures still happen. That's with mobo
manufacturer approved and supplied utilities. How many posts do we get
here a month from folks who have to do an EEINIT or at the very least
re-flash after a failure?
If I was Elecraft I would run away from this potential Pandora's Box
rapidly.
On 4/9/2016 1:43 PM, Ken G Kopp wrote:
Well said, Kevin!
This was my initial intent when I started this thread,
but you've done a better job of stating the obvious.
73!
Ken Kopp - K0PP
--
R. Kevin Stover
AC0H
ARRL
FISTS #11993
SKCC #215
NAQCC #3441
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
