If you try to use the "enhanced" cabling setup in the Owner's manual that uses the accessory cable, the K3 will control which band the KPA500 is on.
I'd use the basic cabling setup shown on page 11, switching both the RF and key line cables. 73, Ron AC7AC -----Original Message----- From: Elecraft [mailto:[email protected]] On Behalf Of Harry Yingst via Elecraft Sent: Friday, April 15, 2016 10:57 AM To: Elecraft Reflector Subject: [Elecraft] Two radios on the KPA500? What would be an easy way to run two radios (a K3 and a generic radio) with the KPA500 Putting an manual switch on the input to the KPA 500 is easy enough, but what aboutthe accessory cable that runs to the K3 and the Key line from the generic radio? Thank you ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
