The configuration includes all the calibration data that is specific to each radio. If you loaded another radio’s config, you would need to do all the calibration over again.
That seems like a very good reason to me. wunder K6WRU Walter Underwood CM87wj http://observer.wunderwood.org/ (my blog) > On Apr 15, 2016, at 4:59 PM, Nr4c <[email protected]> wrote: > > NO. FOR GOOD REASON. > > Sent from my iPhone > ...nr4c. bill > > >> On Apr 15, 2016, at 7:12 PM, Merle Bone <[email protected]> wrote: >> >> I tried to load my current K3 configuration into my new K3S and got an >> error message saying the serial number did not match. Is there >> a reasonable way to load an older K3 configuration into a new >> K3S? >> Thanks, >> Merle - W0EWM >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to [email protected] > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
