On 4/15/2016 11:34 PM, Mike Walkington wrote:
All,
(4) PTT foot switch. What about your
preference for enabling several (ie pickle and foot switch) of these in
parallel
I use (4) PTT foot switch.
I don't understand your "in parallel" question. I have one foot switch
plugged into the K3's rear panel PTT jack, and use it for the Heil GM-5
plugged into the MIC connector on the front panel, and for the Yamaha
CM500 headset plugged into the rear panel MIC and PHONES jacks.
The headphones are always on, but I can't hear the audio because the
phones are clapped together while the speaker is on.
I switch mics with MENU: MIC SEL, which also sets the high/low gain
selection and mic bias on/off.
The Heil mic cable originally was for a Yaesu plug (I think), but I
diked-off the RJ connector, and installed a round Kenwood-style plug to
match the K3's jack.
I did not install a 1/4" phone jack near the round plug because the foot
switch is plugged into the rear panel, and the GM-5's PTT button works
without it.
Now, why did you ask about PTT devices in parallel?
--
73, Mike N4CF
Louisa County, VA USA
Elecraft K3s/100
Carolina Windom up 45'
http://n4cf.mdodd.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
