Something is funky on the PX3 when the KX3 is in AM mode. I have my PBT SSB menu item set for Hi/Lo Cut. When set to NOR there minor differences in behavior in the AM mode, but the end result is the same.
If the bandwidth/shift or Hi/Lo cut is NORMalized, the green bandwidth band on the PX3 sits with it’s edges about 3 KHZ above and 3 KHz below the carrier frequency as you might expect. It’s symmetrical around the carrier. If I open up the HI setting to max (4.2 KHz) and set the LO to minimum, the green band is offset to the high frequency side of the carrier — with the low boundary about 2.2 KHz below the carrier, and the high boundary about 4.4 KHz above the carrier. These points may not be exact, but they were roughly measured using the VFO A marker — close enough to make the point. And just using the usual reduction in background hiss to retune the carrier, it appears most closely tuned when the VFO is set about 0.9 KHZ above the actual carrier frequency, although even then the green band is offset from either the actual or tuned carrier freq. So can anyone explain what is going on, and why the PX3 display (and maybe the KX3) behavior appears so odd in AM mode. Must be something I missed somewhere along the line. Grant NQ5T K3 #2091, KX3 #8342 PS — Sure would be a good thing to port the K3/K3S sync detector to the KX3 … ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
