Well, these are always problems.
1) To avoid the guy 2.5KHz away, cut the high frequency cut off
down low. I frequently operate it at 2.05 or 2.15 KHz. I keep
the low frequency cutoff much more constant at .25 to .36 KHz.
This procedure will keep most of the interfering signal out of
the audio.
2) That weak DX is always a problem. If he is running split and
you have a subreceiver, then adjust the two receiver AF volume
control differently. If the loud signal is on the same
frequency, you can try to adjust the AGC parameters to "even
out" the audio. The AGC SLP parameter is the one to look at
first, but a warning. It is an advanced control, and requires
TECH MD ON to adjust. Many on the list think the K3 comes set
too flat already. But you can always return the settings to the
default listed in the manual if you don't like your results.
73 Bill AE6JV
On 4/27/16 at 2:38 PM, [email protected] wrote:
1. During contests, how to best adjust to hear the station and not the guy
2.5KHz away
2. When trying to hear the weak DX, not be blasted by that guy
from Florida or Texas running a kilowatt.
-----------------------------------------------------------------------
Bill Frantz | gets() remains as a monument | Periwinkle
(408)356-8506 | to C's continuing support of | 16345
Englewood Ave
www.pwpconsult.com | buffer overruns. | Los Gatos,
CA 95032
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
