Karel, What is the reading on the K3S's ALC meter? In order to achieve correct power control in audio data modes, you must set the audio input level so that the meter reads 4-5 bars - not zero as with most other transceivers. If the audio input is at zero bars, the K3S's microprocessor will not be able to control the transmitter output power correctly.
Set the audio level to give you 4-5 bars on the ALC meter,and use the PWR control to select the desired output power. Do not leave the PWR control at full power and use the audio drive level to control output power, as is sometimes recommended for other transceivers - that will not work with the K3 and K3S. 73, Rich VE3KI ON7TA wrote: Somebody mentioned me that my signals goes up and down about 10db when I send out \ digital mode via pc. (psk, simpsk). ( checked it myself via a websdr station close \ to my QTH, so no propagation ) I already switched off TX ALC but there is no difference. Compressor is off, tried \ low and high power, low and high output of pc sound does not change a thing, TX EQ is \ not used, ... When I do the same with my Flex, with the same pc and the same programs I don't have \ this up and down issue. I checked the USB Audio Codec sound card settings, but I don't see any settings in \ there that could cause this issue. Has anybody got an idea about this? It's not a real issue to work digital modes, but \ I'm curious to know of what is causing this. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
