Folks, I'm at the final stages of readying a K3 for a friend. I've gone through every thing I can think of to be sure it is working perfectly. It has all the updates and upgrades available, and it seemed to be working perfectly. That is, till I noticed the 60M is not showing up when changing bands.
I have done the TX calibrations with the Utility and it calibrated at 5336 kHz TxGain LP, HP and at 1MW so its in the radio but when I change bands it bypasses 5 MHz. From 1.60 MHz up it goes: 1.8 3.7 7 10 14 18 21 24 28 50 Using the MW calibration the Utility tested: 1900 kHz TxGain MW 08 3750 kHz TxGain MW 09 5336 kHz TxGain MW 16 7150 kHz TxGain MW 17 10125 kHz TxGain MW 16 14200 kHz TxGain MW 18 18110 kHz TxGain MW 26 21200 kHz TxGain MW 31 24930 kHz TxGain MW 34 29000 kHz TxGain MW 100 52000 kHz TxGain MW 77 I've never seen this before and looking at the manual, I see nothing relating to turning off the 60 meter band or turning it back on. I can manually enter a 5 MHz frequency but when I change bands, it bypasses it again. I must be missing some setting but scanning the manual, I see nothing under bypassing 60 meters or bypassing 5 MHz. Suggestions? 73, Gary KA1J ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
