Don't know about an iMac, I have studiously avoided anything whose name
begins with a lower case "i", but ...
I run W7RN remotely with my K3 and the RRC 1258Mk2 and use N1MM in
contests on a PC. Here's my recipe:
1. Serial cable from control K3 to back of RRC box. This establishes
remote control.
2. USB from RRC front panel connector to PC. When connected, the RRC
box creates 4 virtual COM ports -- COM0, COM1, COM2, and COMExtra. In
device mgr, they will have a "real" COM port assigned in parentheses.
3. Locate the virtual port COM1, and note the "real" port in parens.
That's the port # that goes into N1MM.
The frequency data comes from the remote K3, not my local control K3.
So, if you can translate that into Apple-ese, it should work for you.
73,
Fred K6DGW
- Northern California Contest Club
- CU in the Cal QSO Party 1-2 Oct 2016
- www.cqp.org
On 5/3/2016 5:12 AM, VK5CP wrote:
Hi,
I have a K3/0 and K3 remote station setup using the most recent
hardware/firmware version of Remoterig RRC-1258MkII connected via the mobile
phone network.
At the K3/0 end I use a IMac computer with MacloggerDX - I would like to
connect the K3/0 via USB to the Imac to automatically feed in the freq/mode
data? I have tried but it does not seem to work.
Has anyone worked this out at their station?
Regards
Chris VK5CP
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
