I seem to be having a problem with the AGC control on my K2. With no signal input, when I turn off the AGC the s-meter reads +40 and stays there regardless of rf gain setting whereas the K2 manual indicates that the s-meter should increase when turning the rf gain ccw. Also, I can hear the 1uV signal from an XG2 with the AGC on but not with the AGC off.
Has anyone experienced anything similar with the K2 AGC control not working properly? I am wondering if this is an alignment issue of could it be a bad or wrongly installed component on the circuit board? Any advice greatly appreciated. Jeff Fedison _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
