Please check that ALL connectors are plugged in ALL the way. Sent from my iPhone ...nr4c. bill
> On Jun 1, 2016, at 8:31 PM, Joel Black <[email protected]> wrote: > > I recently acquired a used PX3 and am quite pleased with it. I am, however, > having a difficult time with the carrier null procedure. If memory serves, I > had a problem trying to do the carrier null on an SDR I built five or six > years ago too. > > I never could quite get the signal generator in the PX3 to get to -40. It > stayed around -45. I did write everything down and did try to adjust the > nulls but I’ve either got too much noise in the shack or I just don’t know > what in the world I’m doing. > > Right now, I’m listening on 75 m and I can see the center carrier plus mirror > images of each side of the carrier. The span is set to 50 kHz. > > Any certain way I’m supposed to “hold my mouth” or “stick out my tongue” > while I do this? :) > > I’ll bring home a service monitor from work tomorrow and hope it tunes down > as low as I need it to go. > > 73, > Joel - W4JBB > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
