Doug,
How you wire the KRX3 AUX ant will depend on how you plan to use your
antennas with it.
Normally, the main RX and the sub RX will share the same antenna through
a 3 dB splitter. You don't have to do anything special to share your
single antenna.
However, if you want to use a different antenna on the subRX (necessary
for diversity reception), you have 2 choices.
1) If you have 2 antennas (both capable of transmit), connect the TMP
cable to the KAT3 and when you select the AUX antenna for the subRX, it
will use the non-transmit antenna.
2) If you have receiving only antenna(s), you would want to install the
TMP cable from the KRX3 AUX jack to the BNC connector. Connect the RX
antenna to that BNC jack and select AUX for the subRX.
73,
Don W3FPR
On 6/4/2016 3:23 PM, Doug wrote:
Ok. I'm installing the rx in my k3. But I'm not sure how to wire it for
connection to a antenna. It will be uses for split operation dxing. Any
suggestions will be appreciated Wd8z. Doug
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
