“No internal hardware changes are required to use your MH2 with the Elecraft K3. Setup consists of attaching the microphone, enabling it using the MENU commands and making other front-panel adjustments. Note: The jumper blocks and 5.6 k resistor supplied with your microphone are not used. They are required only when using the MH2 with an Elecraft K2. The K3 can receive microphone input from either front or back panel connectors. Select the front panel connector as follows: 1. Tap MENU and locate MIC SEL with VFO B. 2. Select FP.L or FP.H with VFO A. 3. If FP.H is displayed, tap the 1 button to toggle the display to show FP.L. 4. Tap the 2 button as needed to display bI AS. (This turns on the microphone bias voltage required by the MH2.) Plug the microphone into the K3 front panel 8-pin”
This is from the Elecraft page on using MH2 with K3. Where is this plug in for a MH2 on the front panel? Mine won’t work on the rear panel plug in. I ordered a MH3 as well, II t won’t work either. What microphone are you guys using on the K3S that uses the 8 pin front panel plug? New K3S that I can’t talk on. Leroy AB7CE ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
