The Y adapter was the part I didn't have correct. Thanks Richard, it's working now.
On Fri, Jun 24, 2016 at 11:05 AM, Richard Jones <[email protected]> wrote: > Had the same problem. There is a 'y' adapter that goes from the 2 > cables coming from the KXPA100 into a single plug into the accessory > connection on the KX2. The cable is called the KX2ACBL. Using it and > everything works correctly. You also have to go into Menu setup and turn > PA mode to on. > > Enjoy > > Dick W0PZD. > > On Fri, Jun 24, 2016 at 6:03 AM, Peter Pauly <[email protected]> wrote: > >> I just finished putting together a KXPA100 with ATU. I've got the KX2 >> connected to it via a KXPACBL connected to the accessory jack on the KX2 >> and the CAT5 cable on the amp. The smaller GPIO plug is unconnected. Also >> the BNC of the KX2 is connected to the RF IN on the amp. I put the KX2 in >> PA Mode YES and can dial up the power to 100 Watts on the KX2. KX2 mode >> is >> CW. KXPA100 is in Auto ATU mode, ANT 1. >> >> The transmit light on the KXPA100 never comes on. >> >> If I hit the Tune button on the KX2, it shows at solid 25 Power Out LED >> and >> a 1 SWR LED. >> If I hit the XMIT button on the KX2, nothing happens on the KXPA100. >> If I hit the Tune button on the button on the KXPA100, I get a flashing 25 >> LED (SWR?) on both a known good antenna and a 50 ohm dummy load. >> >> Any suggestions before I contact Elecraft technical support? >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to [email protected] >> > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
