Bob-2 wrote > How? > > Are you a beta tester? Yes. Short summary - the mod is simple IF you have the right parts. Solder a 6.8 ohm resistor across R82 (i.e. in parallel) on the Front Panel Board. No need to remove any panels but unscrew the 3 top and 2 bottom screws holding the FPB to the chassis and then use a flat head screw driver in the 2 bottom slots to pry FPB apart from chassis.
Elecraft provides both 1/10 W SMD (0603 size) and leaded 1/8 W resistors in the kit. 0603 SMD is a bit of a challenge but makes a very neat installation if you're experienced with soldering SMD, or Elecraft will install the mod for you if you email k3support at elecraft.com or call 831-763-4211. 73, Bill W4ZV -- View this message in context: http://elecraft.365791.n2.nabble.com/K-Pod-owner-s-manual-tp7619352p7619362.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
