I received my K-POD this afternoon and proceeded to do the front panel
mod. The instructions say to simply remove the 3 top and 2 bottom front
panel screws and pry off the front panel. In the past I recalled
needing to remove the left side panel but couldn't really remember why.
When I was unable to pry the left side of the front panel loose I
removed the left panel and remembered why I had to do that in the past.
There is a round head screw on the bottom front 2D fastener that must be
removed for the board to slide out. After I removed that screw it was
no problem. The instructions need to include this step.
My K3 is SN 3329. Perhaps later K3s don't have that round head screw.
73, Alan N5NA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
