I only have power-pole's on my K3/10 and KXPA-100.
I installed a power-pole on the CCI 140w linear I built, but would
not do it a second time. None of these power-pole will stay seated
if equipment is physically moved.
I very much like the power connectors used by DEMI on their
transverters but do not have a source for them. I chose 4-pin mic
connectors to use as dc power and PTT jack on the 80w 2m Linear Amp I
built last winter (for twelve customers). Hardly any mics use that
connector anymore so not likely one would connect a mic there <smile>.
For commercial equipment I used multi-pin Mil-spec threaded round
connectors. They cost over $30 so hams would not pay that. But for
hard-duty usage they are super. You can hold the weight of the
Pelican Cased equipment via the cord! Plus they are water-tight.
73, Ed - KL7UW
http://www.kl7uw.com
"Kits made by KL7UW"
Dubus Mag business:
[email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
