Well, the FM filter for the main receiver is mounted on the main RF board. So the 2Meter module must come out, and the sub-receiver, and of course the top and front bottom panel, I also think it is easier to re-install the sub-receiver if you remove the left side panel (with handle).
…bill nr4c > On Jul 19, 2016, at 3:50 PM, mike <[email protected]> wrote: > > I have a K3 with the 2 meter module and second receiver installed. I recently > acquired a FM filter and am wondering how difficult it would be to install > it. Mostly I guess I am looking for an idea on what steps I need to perform > and in what order. I installed the second receiver some time ago after > installing the 2 meter module and remember it was quite involved. Before I > attempt to add the FM filter I want to make sure I am up to the challenge. > Any suggestions would be greatly appreciated. 73 ..mike AI6II > > > > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/How-difficult-is-it-to-install-the-FM-filter-ofr-K3-with-tp7620404.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
