I am not completely understanding the tuning performed using the KX3 with the KXPA100.
First, I’m not even completely sure which mode I should be in: Byp, Man, or Auto. I have three antennas - one is a vertical which is resonant on 40 - 10 except for 17 and 12 m. I have an OCF that is resonant on 40 - 10 *including* 17 and 12 m. I also have a shortened 80 m inverted vee that I have to tune if I go to 75 m. Currently, I have the shortened 80 m antenna selected with my antenna switch. No matter which mode I use, I never hear any relays in the KXPA100 ATU and I never get below about 7.4:1 SWR. The KX3’s ATU works just fine with the same antenna. Pressing the ATU TUNE button on the KX3 starts the 25 LED blinking but stopping the tuning does not stop the 25 LED from blinking. It’s blinking right now and I’m not tuning anything. I’m going to go back and verify all my cabling (I also have a PX3 in the mix) and make sure I haven’t cabled something wrong. Otherwise, what else can I look for? Thanks, Joel - W4JBB ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
