Sid,
In that case, you would set the MIC SEL menu to FP.L as you have it, and
feed the soundcard output to the mic input.
Note that this has nothing to do with your headset that you use for SSB.
Use DATA A mode rather than SSB because that data submode sets
compression to 1-1 and the TX EQ to flat. That setting is independent
of any settings you may have for SSB.
I am just curious why you have not connected the soundcard output to the
Line In jack on the back of the K3 - it is not only more convenient when
switching between SSB and data modes, but it offers transformer
isolation for the soundcard lines.
In either case, adjust the audio level to produce 4 bars solid with the
5th bar flashing on the ALC meter - that is the "no ALC" point for the
K3. Set the power desired with the K3 power knob.
Ignore the "internet" advice to adjust the power using the audio level -
that does not work with the K3. Adjust the power level with the power knob.
73,
Don W3FPR
On 8/10/2016 8:37 PM, Sid Frissell wrote:
Don and Bill-- I am using the front panel mike jack and Mic-select (Data mode)
is set FP.L.
Sid, NZ7M
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
